Pioneer VSX-1131 Basic Manual page 11

> Before start > Hookup
1/2˝
(12 mm)
1 Speaker cable, 2 Subwoofer cable
> Setup > Playback > Part Names
1
For high-
frequency
For low-
frequency
> Advanced Manual
in case of:
Page 8
Connect front speakers compatible with Bi-Amping
connection to the FRONT jacks and the SURROUND
BACK jacks. Make sure you remove the jumper bar fitted
between the woofer jacks and tweeter jacks of the front
speakers. In case of Bi-Amping connection, refer to the
instruction manual of your speakers. Up to two powered
subwoofers can be connected. The same signal is output
from each of the SUBWOOFER jacks.
Setup
0 Bi-Amping connection requires you to change
some settings. Select "Yes" in "Bi-Amp" in "1. Full
Auto MCACC" (

Make sure the exposed wires of the speakers do not stick out of
2
the speaker terminals when connecting. If the exposed wires of
the speakers touch the rear panel or the + and – wires touch each
other, the protection circuit will be activated.
Troubleshooting | Appendix
P19) in the Initial Setup.
11