Hook Up The Throttle - GREAT PLANES QUIK-V6 Instruction Manual

❏
4. Temporarily fasten the back plate mount to the
fi rewall as shown with four 6-32 x 5/8" [16mm] SCHS
(socket-head cap screws). Use the hole in the mount as
a guide to drill an 11/64" [4.4mm] (or 3/16" [4.8mm]) hole
through the fi rewall. Remove the mount.
❏
5. M3 x 10 SHCS and M2.5 x 10 SHCS are included for
mounting your engine to the included back plate mount.
These screws should be slightly longer than the screws that
are in your engine. Remove the back plate from your engine
and fasten the back plate mount with whichever screws are
suitable and a drop of threadlocker on the screws.
❏
6. Mount the back plate mount to the fi rewall with four
6-32 x 5/8" [16mm] SCHS and threadlocker.
Mount the landing gear as illustrated on pages 22 & 23.

Hook Up the Throttle

❏
1. Glue the laser-cut 1/8" [3.2mm] plywood doubler
to the bottom of the laser-cut 1/8" [3.2mm] plywood
throttle servo mount. Test-fi t your servos and make any
adjustments if necessary.
❏
2. Glue the throttle servo mount and the laser-cut 1/8"
[3.2mm] plywood support for the front of the mount into
the fuselage.
Refer to these images to hook up the throttle as described
in the following steps.
17