Procedure For Tilting Down - Yamaha F6C Owner's Manual

Operation
1. Fuel joint cap
7. Hold the rear of the top cowling and fully
tilt the outboard motor up. Slightly lower
the outboard motor from the fully tilted up
position and fit the tilt support bar secure-
ly into the holder located on the clamp
bracket.
1
2
1. Tilt support bar
2. Holder
EMU42950

Procedure for tilting down

F2.5A
1. Slightly tilt the outboard motor up.
2. Slowly tilt the outboard motor down while
pulling the tilt support lever up.
67
1
ZMU07459
3. Loosen the steering friction adjuster by
turning it counterclockwise, and adjust
the steering friction according to operator
preference. WARNING! If there is too
much resistance it could be difficult to
steer, which could result in an acci-
dent.
F4B, F5A, F6C
1. Slightly tilt the outboard motor up.
2. Slowly tilt the outboard motor down while
pulling the tilt support bar up.
ZMU06829
1. Tilt support bar
3. Turn the steering friction adjuster coun-
terclockwise to set the steering friction
according
WARNING! If there is too much resis-
tance it could be difficult to steer,
which could result in an accident.
[EWM00721]
[EWM00721]
1
to operator
ZMU06833
preference.