Throttle Friction Adjuster; Engine Shut-Off Cord (Lanyard) And Clip - Yamaha F6C Owner's Manual

Components
2
1. Start mark " "
2. Notch
EMU39243

Throttle friction adjuster

The throttle friction adjuster provides adjust-
able resistance when the throttle grip is
turned, and can be set according to operator
preference.
To increase resistance, turn the throttle fric-
tion adjuster clockwise.
To decrease resistance, turn the throttle fric-
tion adjuster counterclockwise. When con-
stant speed is desired, tighten the throttle
friction adjuster to maintain the desired throt-
tle setting. WARNING! Do not overtighten
the throttle friction adjuster. If there is too
much resistance, it could be difficult to
turn the throttle grip, which could result in
an accident.
[EWM02261]
F2.5A
1. Throttle friction adjuster
25
1
ZMU06808
1
ZMU07361
F4B, F5A, F6C
1. Throttle friction adjuster
EMU25995
Engine shut-off cord (lanyard) and
clip
The clip must be attached to the engine shut-
off switch for the engine to run. The cord
should be attached to a secure place on the
operator's clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the
cord will pull out the clip, stopping ignition to
the engine. This will prevent the boat from
running away under power. WARNING! At-
tach the engine shut-off cord to a secure
place on your clothing, or your arm or leg
while operating. Do not attach the cord to
clothing that could tear loose. Do not route
the cord where it could become entangled,
preventing it from functioning. Avoid acci-
dentally pulling the cord during normal
operation. Loss of engine power means
the loss of most steering control. Also,
without engine power, the boat could slow
rapidly. This could cause people and ob-
jects in the boat to be thrown forward.
[EWM00122]
1
ZMU06724