Dinette Conversion (With Built-In Table) (If Equipped); Sofa Conversion (If Equipped); Sleeper Sofa Conversion (If Equipped); Bunk Ladder Use - Fleetwood 2014 Terra Storm Owner's Manual

The materials used inside your motor home
have been selected for durability and comfort.
With reasonable care, these materials will
stand up under years of recreational living . The
Maintenance chapter in this manual outlines
care requirements for the various upholstery
fabrics , floor, cabinet , and wall finishes.
Dinette Conversion
(with Built-in Table) (If Equipped)
To convert the dinette into a bed:
1. Remove all the dinette cushions and set
aside, (cushions will be used later).
2. Reach underneath the front center of the
tabletop and release the "position lock"
by turning it into the unlocked position.3.
Lower the table by gently pushing down
on the tabletop until it rests in the bed posi-
tion.
4. Complete the conversion by placing all of
the cushions onto the tabletop.
To convert the bed back to a dinette:
1. Reverse steps 1-4.
Sofa Conversion
To convert a sofa bed into a bed:
1. Remove sofa bolsters (if applicable).
2. Lift front of sofa seat (above front kick panel)
up and out. The back of the sofa will drop
back and down as the seat is pulled outward.
To restore the sofa/lounge:
1. Lift the front edge of the sofa seat up, and
push it back towards rear. The sofa back
will come up.
2. Push the sofa fully into position.
Sleeper Sofa Conversion
To convert a sleeper sofa into a bed:
1. Remove sofa cushions.
2. Lift front of sofa seat (above front kick
panel) up and out. While lifting the seat
out, the middle legs will automatically
unfold into a vertical position.
3. Pull upward on the center of the metal bar,
and rotate it down slowly until the wood
bars rest on the floor.
To restore the sleeper sofa:
1. Lift the front edge of the bedframe up and
rotate it back.
2. Lift the middle section of the bed up and
push it back towards the rear until the bed
is fully into position.
(If Equipped)
(If Equipped)
Living With Your Motor Home
3. Replace the cushions.
Bunk Ladder Use (if equipped)
ASCENDING
1. Locate bunk ladder attachment brackets on
the bed frame rail.
BUNK LADDER ATTACHMENT BRACKETS
BEDFRAME
2. Insert hooks at ends of ladder frame tubes
into brackets until fully engaged.
3. Ladder should be in an angled position to the
floor, with both legs resting evenly on the
floor, and both ladder hooks fully engaged.
4. Stepping on the first rung only, check to
make sure the ladder feels stable and does not
rock. If stable proceed up ladder onto bed.
DESCENDING
1. Visually inspect that ladder hooks are
engaged in the bunk ladder attachment
brackets evenly before descending.
2. Descend down ladder, with the ladder in
front of your body, using the bed and lad-
der framing to steady you as you descend.

Folding Doors/Privacy Curtain

Dividers

(If Equipped)
The dividers allow you to separate areas in the
motor home. They glide on nylon rollers. They are
held closed by a catch. When the dividers are open
for traveling, be sure to attach the hold back latch to
keep them from sliding back and forth.
LEGS SHOULD REST
EVENLY ON FLOOR SURFACE
06-5