Interior And Furnishings; Dinette Conversion (With Built-In Table) (If Equipped); Dinette Conversion (With Free-Standing Table) (If Equipped); Sofa Conversion (If Equipped) - Fleetwood American Eagle User Manual

clearance for your room to safely extend to
the full outward position.
• Remove any other potential obstructions to
room movement.
For operation of the slide-out room the follow-
ing is required:
• Park the RV and level it for stationary use
• Ignition on
• Transmission in neutral
• Parking brake engaged
.II
NOTE
I
Under wet/snow weather conditions, after retracting
the slide-out rooms(s), it may be necessary to towel
off moisture from the end walls.
A
CAUTION
Never attempt to move your motor home with the
slide-out room(s) extended. Damage can occur to the
slide-out or motor home. , .
A
CAUTION
In case of a power failure, the slide-out room can be
retracted manually. Be sure to understand the opera-
tion section as explained in the slide-out systems
Operations Manual in the Owner's Information
Package.
INTERIOR AND FURNISHINGS
The materials used inside your motor home
have been selected for durability and comfort.
With reasonable care, these materials will
stand up under years of recreational living. The
Maintenance chapter in this manual outlines
care requirements for the various upholstery
fabrics, floor, cabinet, and wall finishes.
Living With Your Motor Home
Dinette Conversion
(with Built-in Tab/e) (/f Equipped)
To convert the dinette into a bed:
1. Remove cushions.
2. Lift table, reach underneath, unlatch and
fold the leg(s) up under the table top, or
remove the table leg( s) and if necessary,
store them between the seats.
3. Raise front portion of table several inches
to disengage inserts from the wall supports.
4. Lower table top to the dinette frame to
complete the bed base.
S. Slide seat and back cushion into place over
the bed base.
The under-seat storage may be reached by
raising the cushion platform.
Dinette Conversion
(with Free-Standing Tab/e) (/f Equipped)
To convert the dinette into a bed:
1. Lift table, reach underneath, fold up the
legs under the table top. Secure the legs.
2. Lower table top to the dinette frame to
complete the bed base.
3. Slide the seat and back cushion into place
over the bed base.
The under-seat storage may be reached by
raising the cushion platform.
.II
NOTE
I
Lower the dinette table to the bed position before
transporting the R\I.
Sofa Conversion
(/f Equipped)
To convert a sofa bed into a bed:
1. Remove sofa bolsters (if applicable).
2. Lift front of sofa seat (above front kick panel)
up and out. The back of the sofa will drop
back and down as the seat is pulled outward.
06-5