Interior And Furnishings; Dinette Conversion (With Built-In Table) (If Equipped); Dinette Conversion (With Free-Standing Table) (If Equipped); Sofa Conversion (If Equipped) - Fleetwood 2003 American Eagle Owner's Manual

CAUTION
Never attempt to move your motor home with the
slide-out room(s) extended. Damage can occur to the
slide-out or motor home.
CAUTION
In case of a power failure, the slide-out room can be
retracted manually. Be sure to understand the opera-
tion section as explained in the slide-out systems
Operations Manual in the Owner's Information
Package.
INTERIOR AND FURNISHINGS
The materials used inside your motor home
have been selected for durability and comfort.
With reasonable care, these materials will
stand up under years of recreational living. The
Maintenance chapter in this manual outlines
care requirements for the various upholstery
fabrics, floor, cabinet, and wall finishes.
Dinette Conversion
(with Built-in Tab/e) (If Equipped)
To convert the dinette into a bed:
I. Remove cushions.
2. Lift table, reach underneath, unlatch and
fold the leges) up under the table top, or
remove the table lege s) and if necessary,
store them between the seats.
3. Raise front portion of table several inches
to disengage inselts from the wall supports.
4. Lower table top to the dinette frame to
complete the bed base.
5.
Slide seat and back cushion into place over
the bed base.
The under-seat storage may be reached by
raising the cushion platform.
Living With Your Motor Home
Dinette Conversion
(with Free-Standing Tab/e) (If Equipped)
To convert the dinette into a bed:
1. Lift table, reach underneath, fold up the
legs under the table top. Secure the legs.
2. Lower table top to the dinette frame to
complete the bed base.
3. Slide the seat and back cushion into place
over the bed base.
The under-seat storage may be reached by
raiSing the cushion platform.
~I
NOTE
I
Lower the dinette table
to
the bed position before
transporting the RV.
Sofa Conversion
(If Equipped)
To convert a sofa bed into a bed:
I. Remove sofa bolsters (if applicable).
2. Lift front of sofa seat (above front kick panel)
up and out. The back of the sofa will drop
back and down as the seat is pulled outward.
To restore the sofa/lounge:
1. Lift the front edge of the sofa seat up, and.
push it back towards rear. The sofa back
will come up.
2. Push the sofa fully into position.
Sleeper Sofa Conversion
(If Equipped)
To convert a sleeper sofa into a bed:
I. Remove sofa cushions.
2. Lift front of sofa seat (above front kick
panel) up and out. While lifting the seat
out, the middle legs will automatically
unfold into a vertical position.
3. Pull upward on the center of the metal bar,
and rotate it down slowly until the wood
bars rest on the floor.
06-5
1=;; . . . -... - ...
I~---