Dinette Conversion (With Built-In Table); (If Equipped); Dinette Conversion (With Free-Standing Table) (If Equipped); Dinette Conversion (With Pedestal Table) (If Equipped) - Fleetwood 2010 Pulse Owner's Manual

Living With Your Motor Home
DINETTE CONVERSION
(with Built-in Table) (If Equipped)
To convert the dinette into a bed:
1. Remove cushions.
2. Lift table, reach underneath, unlatch and
fold the leg(s) up under the table top, or
remove the table leg(s) and if necessary,
store them between the seats.
3. Raise front portion of table several inches
to disengage inserts from the wall supports.
4. Lower table top to the dinette frame to
complete the bed base.
5. Slide seat and back cushion into place over
the bed base.
The under-seat storage may be reached by
raising the cushion platform.
DINETTE CONVERSION
(with Free-Standing Table) (If Equipped)
To convert the dinette into a bed:
1. Lift table, reach underneath, fold up the
legs under the table top. Secure the legs.
2. Lower table top to the dinette frame to
complete the bed base.
3. Slide the seat and back cushion into place
over the bed base.
The under-seat storage may be reached by
raising the cushion platform.

NOTE
Lower the dinette table to the bed position before
transporting the RV.
DINETTE CONVERSION
(with Pedestal Table) (If Equipped)
To convert the dinette into a bed:
1. Lift table to disengage from pedestal tubes.
2. Remove tubes from floor bases and store.
3. Lower table top to dinette frame to com-
plete the bed base.
06-12
4. Slide the seat and back cushion into place
over the bed base.
SOFA CONVERSION
To convert a sofa bed into a bed:
1. Remove sofa bolsters (if applicable).
2. Lift front of sofa seat (above front kick panel)
up and out. The back of the sofa will drop
back and down as the seat is pulled outward.
To restore the sofa/lounge:
1. Lift the front edge of the sofa seat up, and
push it back towards rear. The sofa back
will come up.
2. Push the sofa fully into position.
SLEEPER SOFA CONVERSION

(If Equipped)

To convert a sleeper sofa into a bed:
1. Remove sofa cushions.
2. Lift front of sofa seat (above front kick
panel) up and out. While lifting the seat
out, the middle legs will automatically
unfold into a vertical position.
3. Pull upward on the center of the metal bar,
and rotate it down slowly until the wood
bars rest on the floor.
To restore the sleeper sofa:
1. Lift the front edge of the bedframe up and
rotate it back.
2. Lift the middle section of the bed up and
push it back towards the rear until the bed
is fully into position.
3. Replace the cushions.

Bunk Ladder Use

ASCENDING
1. Locate bunk ladder attachment brackets on
the bed frame rail.
(If Equipped)