Dinette Conversion (With Built-In Table) (If Equipped); Dinette Conversion (With Free-Standing Table) (If Equipped); Sofa Conversion (If Equipped); Sleeper Sofa Conversion (If Equipped) - Fleetwood 2013 Recreational Vehicle Owner's Manual

Living With Your Motor Home
Dinette Conversion
(with Built-in Table) (If Equipped)
To convert the dinette into a bed:
1. Remove all the dinette cushions and set
aside, (cushions will be used later).
2. Reach underneath the front center of the
tabletop and release the "position lock" by
turning it into the unlocked position.
3. Lower the table by gently pushing down
on the tabletop until it rests in the bed posi-
tion.
4. Slide seat and back cushions into place
over the bed use.
The under-seat storage may be reached by
raising the cushion platform:
Dinette Conversion
(with Free-Standing Table) (If Equipped)
To convert the dinette into a bed:
1. Lift table, reach underneath, fold upthe legs
under the table top. Secure the legs.
2. Lower table top to the dinette frame to
complete the bed base.
3. Slide the seat and back cushions into place
over the bed base.
The under-seat storage may be reached by
raising the cushion platform:
NOTE
✓
Lower the dinette table to the bed position before-
transporting the RV.
Dinette Conversion
(with Pedestal Table) (If Equipped)
To convert dinette into a bed:
1. Lift table to disengage from pedestal tubes.
2. Remove tubes from floor bases and store.
3. Lower table top to dinette frame to complete
the bed base.
06-14
4. Slide the seat and back cushions into place
over the bed base.
Sofa Conversion
(If Equipped)
To convert a sofa bed into a bed:
1. Remove sofa bolsters (if applicable).
2. Lift front of sofa seat (above front kick
panel) up and out. The back of the sofa will
drop back and down as the seat is pulled
outward.
To restore the sofa/lounge:
1. Lift the front edge of the sofa seat up, and
push it back towards rear. The sofa back
will come up.
2. Push the sofa fully into position.
Sleeper Sofa Conversion
(If Equipped)
To convert a sleeper sofa into a bed:
1. Remove sofa cushions.
2. Lift front of sofa seat (above front kick
panel) up and out. While lifting the seat
out, the middle legs will automatically
unfold into a vertical position.
3. Pull upward on the center of the metal bar,
and rotate it down slowly until the wood
bars rest on the floor.
To restore the sleeper sofa:
1. Lift the front edge of the bedframe up and
rotate it back.
2. Lift the middle section of the bed up and
push it back towards the rear until the bed
is fully into position.
3. Replace the cushions.