Secondary Air Tube Replacement Instructions; Replacement Parts List - Lopi Revere Owner's Manual

Secondary Air Tube Replacement Instructions

REMOVING THE
SECONDARY AIR TUBES
Follow the directions to the right.
To remove the front tube, the
baffle firebricks and front baffle
support must be removed first.
NOTE: The back two
secondary air tubes are
different from the front
tube. Make sure to
procure the correct air tube
when replacing.
NOTE: When replacing, make sure the
two holes on the secondary air tube
sleeve line up with the hole on the
secondary air tube and the hole on the
air tube stub welded to the side air
channel.
R P
EPLACEMENT ARTS
PART
Door Gasket
Glass Gasket
Door Glass
Retainer for Door Glass
Handle for Door
Door Handle
Door Cam
Air Control Handle
Firebrick
Front Secondary Air Tube
Middle and Rear Secondary Air Tube
Front Baffle Support
Center Baffle Support
Bypass Support
Bypass Support Gasket
Bypass Damper
Bypass Yoke and Bypass Extender
Bypass Handle
Owner's Manual
Air Control Slider
Bypass Pull Tool
M
AINTAINING
Pry out both pins on the secondary
air tube sleeve (use a screwdriver).
Slide the secondary air
tube sleeve to the left.
Slide the secondary air tube to the right
until it disengages from the left side.
L
IST
PART DESCRIPTION
Black 7/8" dia. Fiberglass rope 54" long
Black 3/4" x 1/8" fiberglass channel tape 47" long
5 mm neoceram, 8 7/8" tall @ center, 15 3/8" wide
Cast steel retainer attaches to door with ten screws (included)
Brass spring (1/2")
Steel shaft with threaded end (includes spring handle)
Cast brass
Brass spring (3/8")
1 1/4" x 4 1/2" x 9" silicon based refractory - some firebrick will require cutting
16 7/8" long with 3/16" dia. holes every 1/2", includes two pins
16 7/8" long with 1/8" dia. holes every 1/2", includes two pins
17 3/4" long, 1 1/2" angle iron welded to bent 2" deflector
17 7/8" long, Two 1 1/2" angle irons welded together to form a "t"
20 3/4" Long, 5" Wide, 1/2" Thick
28" Long, 1 1/2" wide, 1/2" thick Kaowool
5 1/2" by 5 1/2", 5/16" thick steel, two 7/8" tubes welded to top for yoke
All 3/8" dia. Rod, 5 3/8" (before bending) yoke welded to 4 1/2" rod, + 4 1/2" extender
Cast iron eye bolt
This document
Steel plate with air control rod
Tool used to adjust bypass
Y A
OUR PPLIANCE
Pin
Side Air Channel
(Welded to side of Firebox)
3.
(C )
ONTINUED
Secondary Air
Tube Sleeve
1.
2.
Air Tube Stub
(welded to the
side air channel)
4.
P 25
AGE