Insert With Direct Connection (Z.c. Fireplace); Insert With Face Seal Connection - Lopi Revere Owner's Manual

I
NSERT WITH
D
IRECT
C
ONNECTION
(Z.C.
F )
IREPLACE
NOTE:
Direct
connections
require
installation of
an airtight
block-off plate
or damper
adapter (see
"Block-off
Plate
Installation"
for details on
constructing
and installing a
block-off
plate).
I
NSERT WITH
F S
ACE EAL
C
ONNECTION
NOTE:
Face seal
connections
require
installation of
the surround
panels and
insulation (see
the section
"Surround
Panels
Installation"
on page 29).
NOTE: This installation may be
used with a masonry or zero
clearance fireplace. This
illustration depictsw a zero
clearance insert, all requirements
in the section "Zero Clearance
Fireplace Requirements" must be
fulfilled prior to installation.
Combustible Mantle
Surround Panels
See the section
"Insert Placement
Requirements" for
minimum clearances
and hearth required.
Optional
Telescoping Legs
NOTE: This installation may be
used with a masonry fireplace
only. The requirements in the
section "Masonry Fireplace
Requirements" must be fulfilled
prior to installation.
Flue Liner
Combustible Mantle
Surround Panels with
insulation (see "Surround
Panels" installation
instructions in the back of
the manual)
See the section "Insert
Placement Requirements"
for minimum clearances
and hearth required.
I I
NSERT NSTALLATION
No modification to the firebox
of the z.c. fireplace is allowed.
(C .)
ONT
P
AGE
Stainless steel
chimney connector
must Extend 1' past
the block-off plate
or to the flue liner
Damper must
be removed
Block-off plate or
damper adapter
Z.C. (Metal) firebox
NOTE: It is
recommended your
chimney have a
minimum 28 and a
maximum of 144
square inch
cross-sectional area
to use a face seal
connection, otherwise
your chimney maynot
have sufficient draw
for the fireplace insert
to operate correctly.
Airtight Insulated
Clean-Out
Remove damper
or wire it open
11