This unit allies quality with reliability and ease of installation. It comprises : • A low height casing (KXL 24/30 : 230 mm, KXL 36/45 : 300 mm) to be flush-fitted easily into all types of suspended ceilings. • Three fan (ventilation) speeds.
TECHNICAL SPECIFICATIONS These characteristics • • • • • • are provided for information • • • purposes only and are • • • subject to change without y t i prior notice. y t i œ c i f c i t •...
HEATING CAPACITY KXL 24 Single phase Indoor temperature 15° C Dry Bulb 20° C Dry Bulb 25° C Dry Bulb Outdoor temperature (° C Wet Bulb) KXL 30 Single phase Three phase Indoor temperature 15° C Dry Bulb 18° C Dry Bulb 20°...
COOLING CAPACITY KXL 24 Single phase Indoor temperature 24° C Wet Bulb 22° C Wet Bulb 20° C Wet bulb 18° C Wet Bulb Outdoor temperature (° C Dry Bulb) KXL 30 Single phase Three phase Indoor temperature 30° C Dry Bulb - 50% Relative Humidity Outdoor temperature (°...
COOLING CAPACITY KXL 36 Single phase Indoor temperature Outdoor temperature (° C Dry Bulb) 30° C Dry Bulb - 50% Relative Humidity 26° C Dry Bulb - 50% Relative Humidity 23° C Dry Bulb - 50% Relative Humidity KXL 36 Three phase Indoor temperature 30°...
Page 10
COOLING CAPACITY KXL 45 Three phase Indoor temperature Outdoor temperature (° C Dry Bulb) 30° C Dry Bulb - 50% Relative Humidity 26° C Dry Bulb - 50% Relative Humidity 23° C Dry Bulb - 50% Relative Humidity...
HEATING MODE POWER INPUT KXL 24 Single phase Indoor temperature 15° C Dry Bulb 20° C Dry Bulb 25° C Dry Bulb Outdoor temperature (° C Dry Bulb) KXL 30 Single phase Three phase Indoor temperature 20° C Dry Bulb 18°...
Page 12
HEATING MODE POWER INPUT KXL 36 Single phase Indoor temperature 20° C Dry Bulb 18° C Dry Bulb 15° C Dry Bulb Outdoor temperature (° C Dry Bulb) KXL 36 Three phase Indoor temperature 20° C Dry Bulb 18° C Dry Bulb 15°...
Page 13
HEATING MODE POWER INPUT KXL 45 Three phase Indoor temperature 20° C Dry Bulb 18° C Dry Bulb 15° C Dry Bulb Outdoor temperature (° C Dry Bulb)
Page 14
COOLING MODE POWER INPUT KXL 24 Single phase Indoor temperature 24° C Wet Bulb 22° C Wet Bulb 20° C Wet Bulb 18° C Wet Bulb Outdoor temperature (° C Dry Bulb) KXL 30 Single phase Three phase Indoor temperature 30°...
Page 15
COOLING MODE POWER INPUT KXL 36 Single phase Indoor temperature 30° C Dry Bulb - 50% Relative Humidity Outdoor temperature (° C Dry Bulb) 26° C Dry Bulb - 50% Relative Humidity 23° C Dry Bulb - 50% Relative Humidity KXL 36 Three phase Indoor temperature...
Page 16
COOLING MODE POWER INPUT KXL 45 Three phase Indoor temperature 30° C Dry Bulb - 50% Relative Humidity Outdoor temperature (° C Dry Bulb) 26° C Dry Bulb - 50% Relative Humidity 23° C Dry Bulb - 50% Relative Humidity...
Dimensions in mm DIMENSIONS Side Electrical terminal view block access Front view GC 24 Outdoor unit Liquid Air blowing Flare connector grille Overhead view Free clearances Mounting blocks Underside (Heatpump models : 150 mm AIR INTAKE AIR BLOWING...
Dimensions in mm DIMENSIONS Side view Electrical terminal Front view block access Flare connector Electrical terminal block access GCN 30 Outdoor unit Liquid Air blowing grille Overhead view Free clearances Mounting blocks Underside (Heatpump models : 150 mm AIR INTAKE AIR BLOWING...
Dimensions in mm DIMENSIONS Side view Electrical terminal block access Flate connector Front view Liquid GCN 36/45 Outdoor units Air blowing grille 4 oblong holes : 13x10 (H8 screws) Overhead view Free clearances to the rear : 100 mm to the front : 500 mm Underside (heatpump models) : AIR INTAKE 150 mm...
INDOOR UNIT INSTALLATION To flush fit the KXL indoor unit into a suspended ceiling, make a 880 x Refer to detailed fitting 880 mm opening. Drill 4 holes to a depth of 45 to 50 mm at the chosen locations in the ceiling and install the hooks supplied as accessories. The instructions in the installation unit is attached by threaded rods.
Dimensions in mm OUTDOOR UNIT INSTALLATION There are two installation possibilities : 1°) Floor mounting Rubber pad Anchoring screw Concrete base 2°) Suspended mounting AIR INTAKE AIR BLOWING Wall bracket (not supplied)
CONNECTIONS The refrigeration and electrical connections to be made between the two units are comprehensively explained in the installation manual supplied with the equipment. CONNECTION OPENINGS • AIR TREATMENT CABINET (ST) FLARE connectors located on the side of the appliance. Electrical connection box with snap connectors located beside the FLARE connectors.
REFRIGERATION CONNECTIONS The cassettes are designed for refrigeration connections to the outdoor units by means of pipes with Flare connectors (refrigeration quality copper pipes with ends equipped with Flare nuts and insulated along their entire length). Various standard pipe lengths equipped with Flare connectors are available from the factory : 2 - 5 - 8 m.
ELECTRICAL SPECIFICATIONS a i l • • • a i l • • • * IMPORTANT These values are provided for information purposes only. They must be checked and adjusted to comply with current standards. They may vary in relation to the mode of installation and the type of conductors used.
ºC INFRARED 7:00 18:00 I FEEL I FEEL I FEEL 10:36 REMOTE CONTROL AUTO 1 2 Wk I FEEL SLEEP CLEAR RESET FUNCTION 1° Remove the battery. 2° Simultaneously press these 4 keys until the symbols disappear. 3° Replace the battery. The 4 keys concerned are : CLEAR –...
USE OF THE FASCIA-MOUNTED THE CONTROL PANEL Remote control signal receiver Manual control button Power "ON" light HEATING mode light Unit in OPERATION light PROGRAMMING light...
Page 35
RCW-2 WALL MOUNTED INFRARED A wall mounted hardwired remote control is available as an accessory. REMOTE It groups together all the air conditioning management functions of your air conditioner (refer to description below). CONTROL (accessory) Display screen. Keys for raising and lowering the set temperature. Ventilation (fan) mode selection : Low speed.
FILTRATION Cleaning the air filter • The air filter prevents dust and other airborne particles penetrating inside the unit. If the unit is in operation for extended periods, the filter should be cleaned every two weeks. • If the dust build-up is too thick to be cleaned, the filter must be replaced with a new filter (supplied as an accessory).
Need help?
Do you have a question about the KXL 24 and is the answer not in the manual?
Questions and answers
KXL45NT POTENZA TOTALE IN RAFFRESCAMENTO
The total nominal cooling capacity of the Airwell KXL 24 is 7150 W.
This answer is automatically generated