Powering Terminal; Card Readers; Nfc/Contactless; Modem Configurations - Exadigm NX1200 User Manual

7.0

Powering Terminal

To power on terminal press red Power key
until beep is heard. The boot up process will
display.
To power down terminal tap the red Power
key briefly, the message shown will appear.
Press [ENTER] to complete process.
8.0

Card Readers

Swipe card through reader with the magnetic
stripe facing down and toward the terminal.
Insert Smart Card into smart card reader slot
located on the bottom front side of the
terminal.
9.0

NFC/Contactless

Tap the NFC card
compartment.
10.0

Modem Configurations

Ensure that the terminal is properly connected to an active power source.

Dial

Connect the phone cord to the LINE port on the back of the terminal.

GSM/GPRS

Before you use the terminal to do live transactions with TCP/IP connections, you need to make sure the
modem is activated by inserting the SIM card. Contact your network carrier, ISO or ExaDigm to confirm
activation.

Ethernet

Connect the Ethernet cable to the Ethernet port (LAN) on the back of the terminal.

WiFi

Connect the mini USB stick to the USB port on the side of the NX1200.
© 2014 ExaDigm, Inc.
over the paper
Page 7 of 16
NX1200 User Guide
Power OFF
[ENTER] Power OFF
[ENTER] or [CANCEL]
Rev. 1/0614