Then with two screws removed in step 10a, secure
the side burner from underneath to the Side Burner
Shelf (K). As shown in Fig. 26.
Connect ignition wire from Firebox Assembly (C)
control panel to the side burner igniter pin from
underneath the Side Burner Shelf & Control Panel
(J). As shown in Fig. 26.
c
Put the side burner control knob back on. As
shown in Fig.26.
Fig. 26.
K
Note: After completing side burner installation,
make sure here has no more than a 3 mm gap
between igniter pin and burner. As shown in Fig. 27.
Fig 27
..........
•
,
fjJ
---_
J
\\\
/
\
,/
",,j--Side
burner
Side burner
Igniter wire _\
Fig. 28.
11. Install the Grease Tray
a)
Attach the grease cup bracket (N) to the grease
tray (P) by using four 5/32"x10mm 430SS (CO)
and four M4 flat washer (FF) which are in the
hardware pack. As shown in Fig. 28.
P
\
23