Install The Filament Guide Tube; Install The Filament Spool Holder; Mounting The Filament Spool; Attaching The Power Cord - CraftUnique CraftBot User Manual

2. INSTALL THE FILAMENT GUIDE TUBE

•
Locate the filament guide tube.
•
Insert one end of the filament guide tube into the guide tube holder
on top of the CraftBot appliance.
•
Push the other end into the hole on the top of the extruder.

3. INSTALL THE FILAMENT SPOOL HOLDER

• Locate the filament spool holder.
• Using a hex wrench, install the filament spool holder next to the
filament guide tube holder.

4. MOUNTING THE FILAMENT SPOOL

•
Open the box containing the PLA filament and remove the filament
spool from the bag.
•
Fit the filament spool onto the filament spool holder so that the lead
end keeps its course when the filament is fed into the guide tube
holder.

5. ATTACHING THE POWER CORD

•
Ensure that the power switch on the CraftBot is set to the OFF position.
• Find and then insert the AC power cord into the power input on the
back of the CraftBot.
CraftBot
8