Loading The Filament - CraftUnique CraftBot User Manual

•
Repeat the process with the two back knobs. First the right back, then the left back knob will be adjusted.
Before switching from knob to knob, please remove and replace the leveling card as necessary.
•
Process is repeated twice to make sure that all 3 knobs are in the correct position.
•
As a result, the building plate should be evenly calibrated.
•
You can return to the main menu by pressing the right arrow.

5. LOADING THE FILAMENT

1. Remove the filament guide tube from the insert hole on the top of the extruder.
2. Insert the filament from the spool into the end of the filament guide tube where it attaches to the
filament guide tube holder. Make sure that the filament spool feeds toward the guide tube holder
(from the bottom up) so that the filament keeps its course. This way you avoid any unnecessary
bending of the filament. To have a clean edge, cut the end of the filament with scissors, if needed.
3. Feed the filament all the way through the guide tube until it comes out the other end.
CraftBot
10