Unpacking The Craftbot Printer; Assembling The Craftbot Printer; Install The Filament Guide Tube Holder - CraftUnique CraftBot User Manual

UNPACKING
THE CRAFTBOT PRINTER
3
1. Place the CraftBot box on the ground on a level surface. Make sure that there is a lot of open space
around you.
2. Open the box with care, not to damage the contents if using a blade.
3. Remove the protective foam insert. You will find the Quick Starter Guide located within the top
protective foam insert.
4. There is a cradle inserted, which contains the accessories (including a pen drive with a copy of
the CraftBot User Manual) and a spool of filament. Remove the cradle with care as it supports the
extruder during shipping.
5. Now you will find the CraftBot 3D printer itself completely enclosed in a protective plastic bag. Open
the plastic covering.
6. Firmly grasp the frame of the CraftBot. Consider its weight. Request physical help if needed. Make
sure not to touch the extruder or the electronic panel inside the appliance! Lift it from the plastic
and out of the box.
7. Place the CraftBot 3D printer on a stable and level surface with sufficient space surrounding.
ASSEMBLING
THE CRAFTBOT PRINTER

1. INSTALL THE FILAMENT GUIDE TUBE HOLDER

•
Select the desired position for the tube holder. Keep in mind that the spool holder must be installed
directly next to the guide tube holder.
•
Locate the guide tube holder.
•
Using a hex wrench, install the guide tube holder onto the top of the CraftBot.
CraftBot
4 6
7
7