Important; Warnings - CraftUnique CraftBot User Manual

IMPORTANT

Read this user manual carefully before you use the appliance and save it for future reference.
All information in this User Manual is subject to change at any time without notice and is provided for
convenience purposes only. CraftUnique reserves the right to modify or revise this User Manual in its
sole discretion and at any time. By using the manual you agree to be bound by any modifications and/or
revisions. For up-to-date information contact the CraftUnique Service Support (support@craftunique.com).

WARNINGS

• Check if the voltage indicated on the bottom of the appliance corresponds to the local mains voltage
before you connect the appliance.
• Do not immerse cord, plug or main body in water or any other liquid. This may cause electrical
shock.
•
Do not use the appliance if the plug, the mains cord or the appliance itself is damaged or not
operating properly.
•
If the mains cord is damaged, you must have it replaced in order to avoid a hazard.
•
Only connect the appliance to grounded wall socket.
•
Keep the mains cord away from hot surfaces.
•
Do not let the mains cord hang over the edge of the table or worktop on which the appliance stands.
•
Keep the appliance and its cord out of the reach of children.
•
This appliance can be used by children aged from 8 years and above and by persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge only under supervision
and adequate instruction concerning use of the appliance in a safe way and if they understand the
hazards involved. Cleaning and user maintenance shall not be made by children.
• Children can receive great educational benefits from designing 3D objects, but the printing process
should not be done by small children.
• Do not touch moving parts or heated elements, it can cause injuries.
• Never reach inside the machine when turned on. Different parts of the machine (mainly the extruder
and heated build plate) operate at very high temperatures and can cause severe burns.
•
Never leave the CraftBot 3D printer unattended while it is plugged in, and in operation.
•
Make sure that the power supply is off and that the power cord is disconnected before servicing.
Allow at least 5 minutes for the device to cool down after unplugging it before reaching inside to
service.
•
Always turn off the printer and disconnect from the computer when it is not being used.
CraftBot
4