AT&T E560-2 User Manual page 14

5.8 ghz expansion handset for use with at&t model e5640/e5643b/e5644b/e5655

Hide thumbs Also See for E560-2:

Table of Contents

Re-registering a handset

To re-register a handset to a new telephone base

• Make sure the handset battery is properly installed and

charged.

• Unplug the old telephone base. The handset will display

SEARCHING....

• Install the new telephone base by plugging it into an electrical

outlet and telephone jack.

• Press and hold the

SELECT/

ENTER BASE ID.

• Enter the 15-digit base ID code located on the bottom of the

E5640, E5643B and E5644B telephone base. To find the number

on the E5655, go to the telephone base, press

on the telephone base and scroll down to highlight DISPLAY

BASE ID, then press

• After entering the code, press

code and complete registration.

NOTE: If an invalid base ID code is entered, you will hear an error tone and the

handset will continue to display ENTER BASE ID. To make corrections while entering

the code, erase digits by pressing the

Once a valid base ID code is entered and accepted by the

telephone base, the new handset will be assigned the next

available handset number (Handset 2, Handset 3, or Handset

4). A maximum of four handsets can be registered to each

telephone base.

key until the handset displays

SELECT/

key.

DELETE/

/MENU

SELECT

to accept the

Table of Contents

E560-5