6 Operation
WARNING
Disassembly of the
ESG Plus head
14
6.4
Replacing grinding wheels
Danger to injury to hands though unintentional activation of the ESG Plus!
Do not switch on the ESG Plus while changing the grinding wheel.
Pull out the power plug.
1. Dismantle and remove the cylinder head screw with collar (M4x15) at the
ESG Plus head. Do not remove the arrest nut (1).
2. Remove the ESG Plus head.
3. Slide a 2.4 mm pin through cross hole and motor shaft (rotation of the
grinding wheel is prevented).
4. Loosen and remove the grinding wheel screw (cylinder head screw with
washer M4x6).
5. Turn the diamond grinding wheel or insert a new grinding wheel.
6. Insert the grinding wheel on the shaft.
The hole of the diamond grinding wheel has to be inserted centrally on
the motor shaft.
7. Tighten the Torx screw and assemble the ESG Plus grinding head to the
motor.
(12.07) MT_ESG Plus_BA_04_790052774_07.doc
Operating instructions with spare parts list ESG Plus
1
orbitalum tools gmbh