Combination Of Grinding Angle And Electrode Diameter; Sharpening Electrodes - Orbitalum ESG Plus Operating Instructions With Spare Parts List

6 Operation
Note
12
6.2.1

Combination of grinding angle and electrode diameter

15°
22,5°
6.2.2

Sharpening electrodes

1. Insert the electrode with the corresponding hole diameter and the desired
angle until the grinding wheel is touched.
2. The electrode tip is sharpened evenly by turning the electrode slowly.
Slow and even rotating motion results in a good and exact sharpening result
(longitudinal grind). If the electrode is not turned, then it is flat ground to the
selected angle.
(12.07) MT_ESG Plus_BA_04_790052774_07.doc
Operating instructions with spare parts list ESG Plus
18°
30°
orbitalum tools gmbh