Vertically With New Chimney System; Vertically Into Existing Chimney System - Golden Eagle ECONOMY SERIES 5040 Owner's Manual

C. VERTICALLY WITH NEW CHIMNEY SYSTEM
(Refer to Figure 10)
NOTE: Follow PL-Vent chimney manufacturer's instructions.
OPTION: To achieve a center vertical installation a 45º elbow
and a clean-out tee can be used to offset the pipe from the
exhaust outlet to the rear center of the stove.
OPTION: Install PL-Vent elbow in place of clean-out tee. Locate
stove. Drop plumb bob to center of tee outlet, mark point on
ceiling. Install ceiling support and PL-Vent pipe per PL-Vent
manufacturer's instructions.
1. Always maintain 3" clearance from combustible materials.
When passing through additional fl oors or ceilings, always
install fi restop spacer.
2. After lining up for hole in roof, cut either a round or square
hole in roof, always 3" larger all the way around pipe. Install
upper edge and sides of fl ashing under roofi ng materials,
nail to the roof along upper edge. Do not nail lower edge.
Seal nail heads with non-hardening waterproof mastic.
3. Apply non-hardening, waterproof mastic where the storm
collar will meet the vent and fl ashing. Slide storm collar down
until it sits on the fl ashing. Seal and install cap. Mobile home
installations must use a spark arrester.
D.

VERTICALLY INTO EXISTING CHIMNEY SYSTEM

Adapters are available to adapt from 3" PL-Vent to 6" or 8"
Class-A chimney. (Figure 11a)
As an alternative, 3" or 4" PL-Vent can be run inside existing
chimney to termination. (Figure 11b)
This is the preferred method.
Follow guidelines for equivalent vent length.
INSTALLATION INSTALLATION
L -VENT ADAPTER
APPLIANCE
12" MINIMUM CLEARANCE
TO ROOF
VERTICAL ROOF VENT
3" MINUMUM
CLEARANCES TO
COMBUSTIBLES
3" MINUMUM
CLEARANCES TO
COMBUSTIBLES
CLEANOUT
TEE
TO
FIGURE 10
PELLET VENT TO
UNIVERSAL
CHIMNEY ADAPTER
CONNECTOR
(SPV-CA)
FIGURE 11a
PELLET NOTE:
THIS METHOD
VENT
IS PREFERRED
FIGURE 11b
ATTIC
INSULATION
SHIELD
45 DEGREE ELBOW
EXISTING
CHIMNEY
SYSTEM
EXISTING
CHIMNEY
SYSTEM
9