Motorola CM300TM User Manual page 64

Restore Channels to the Scan List
Power off the radio then turn it on. – OR – Press the preprogrammed Scan button
to stop the scan. The Deleted Nuisance Channels are restored to the scan list.
G H
– OR – or to select a channel that has not been preprogrammed by your
dealer/programmer to stop Scan. Once you return to the original channel, the
deleted nuisance channels are restored to the scan list.
Send a Selective Call
1. From the Selective Call menu, select or enter desired radio ID number.
2. Press PTT button to send the call.
3. Press and hold the PTT button to speak; release to listen.
Receive a Selective Call
1. When a Selective Call is received, the radio displays
the calling radio; the yellow LED flashes and two tones are heard.
2. Press PTT button to acknowledge the call.
3. Press and hold the PTT button to speak; release to listen.
LED Indicators
LED State/Color
Radio Call
Red Transmitting
Flashing Red Receiving
Flashing Red Channel Busy
Scan
Flashing Green Scanning for activity
Call Alert
Flashing Yellow Indicates receiving a Call Alert
Yellow Indicates sending a Call Alert
Selective Call
Flashing Yellow Indicates receiving a Selective Call
Yellow Indicates sending a Selective Call
Sticky Monitor/Open Squelch
Yellow While monitoring
F
and the name or ID of
Indication
Audio Indicators for Programmable Buttons
Programmable Buttons
Scan
Power Level
Squelch
Repeater/Talkaround
VOX
Local/Distance
Sticky Monitor/Open
Squelch
Home Revert Memory
Channel (1&2)
Story Memory Channel
(1&2)
D
Menu Mode
Radio Call
Scan List Edit
Speed Dial
Phone Mode
Option Board
Escalert
Positive Negative
Indicator Tone Indicator Tone
Start Stop
High Low
Tight Normal
Does not use Uses repeater
repeater
Enabled Disabled
Local Distance
– Enabled
– Enabled
– Stored
– Accessed
– Enabled
– Enabled
– Enabled
– Enabled
Enabled Disabled
Enabled Disabled