Panasonic CS-MA95KE Service Manual page 61

10.2. INDOOR UNIT
10.2.1. SELECT THE BEST LOCATION
(Refer to "Select the best location"
section)
10.2.2. HOW TO FIX INSTALLATION
PLATE
The mounting wall is strong and solid enough to prevent it from
the vibration.
: Unit centre should be at more than 450 mm at right and left
of the wall.
The height should be more than 195 mm from the ceiling.
: From installation plate end to unit left side end is 50 mm.
: From installation plate end to unit right side end is 50 mm.
: Connecting cable should be about 750 mm from this line.
(Only for left rear piping)
: For left side piping, piping connection for liquid should be
here.
: For left side piping, piping connection for gas should be
here.
1. Mount the installation plate on the wall with four screws.
(If mounting the unit on the concrete wall consider using
anchor bolts.)
• Always mount the installation plate horizontally by
aligning the marking-off line with the thread and using a
level gauge.
2. Drill the piping plate hole with ø70 mm hole-core drill.
• Line according to the arrows marked on the lower left
and right side of the installation plate. The meeting point
of the extended line is the centre of the hole.
• Drill the piping hole at either the right or the left and the
hole should be slightly slanted to the outdoor side.
CS-MA95KE CU-MA185KE / CS-MA125KE CU-MA245KE / CS-MA75KE / CS-MA125KE CU-MA195KE
10.2.3. TO DRILL A HOLE IN THE WALL
AND INSTALL A SLEEVE OF
PIPING
1. Insert the piping sleeve to the hole.
2. Fix the bushing to the sleeve.
3. Cut the sleeve until it
extrudes about 15 mm from the wall.
Caution
When the wall is hollow, please be sure to use the
sleeve for tube ass'y to prevent dangers caused by
mice biting the indoor/outdoor connecting cable.
4. Finish by sealing the sleeve with putty or caulking
compound at the final stage.
10.2.4. INDOOR UNIT INSTALLATION
1. For the right rear piping
2. For the right and right bottom piping
61