Removing The Inverter Board - Panasonic CF-Y4 Service Manual

5. Remove all the hooks (6 at the top, 5 at the bottom and 3
on each side) of the LCD Front Case Ass'y, and remove the
LCD Front Case Ass'y.
Hook position
Hinge (L)
Hinge (R)
* The Hooks can be removed more easily by repeatedly
inserting a screwdriver with a protective cloth wound around
it between the LCD Front Case Ass'y and LCD Rear
Case Ass'y, and sliding it.
* Take care not to scratch or mark the exterior.
LCD Front Case
LCD Rear Case
2.2.15. Removing the LCD Unit/LCD Cable
· reparation: Make sure that the steps in sections 2.2.1 to
2.2.4 and section 2.2.14 have been taken first.
1. Remove the two Screws (c) of the LCD Hook.
Screw (c): DFHE5025XA
2. Lift the LCD Unit from the LCD Rear Case Ass'y, and turn
it over in front.
3. Peel off the two tapes anchoring the LCD Cable (Inverter).
4. Disconnect the Inverter Cable and LCD Cable (Inverter)
from the Inverter Board, and then remove the LCD Unit.
5. Peel off the Conductive Cloth anchoring the LCD Cable.
6. Disconnect the LCD Cable form the LCD Connector.
LCD Rear Case Ass'y
Tape
Conductive Cloth
LCD Cable
LCD Cable
(Inverter)
* The Conductive Cloth cannot be re-used.
Use a new one instead.

2.2.16. Removing the Inverter Board

· Preparation: Make sure that the steps in sections 2.2.1
to 2.2.4 and in sections 2.2.14 and 2.2.15 have been
taken first.
1. Peel off the tape from the LCD Rear Case Ass'y, and then
remove the Inverter Board.
Tape
2-9
Screw(c)
CN1
LCD Hook
Inverter Board
Tape
LCD unit
LCD Rear Case Ass'y
CN2