Removing The Inverter Board - Panasonic CF-Y2 Service Manual

2. Remove the Screw (Z) from the Hinge (L) and the Screw (Z)
from Hinge (R).
Screw (Z): DXHM0002ZA
3. Remove each of the Screws (a) and (b) from the LCD Front
Cabinet Ass'y.
Screw (a): DXQT26+D4FNL
Screw (b): DFHE5025XA
4. Remove the three hooks near the Hinge (L) and (R), and
then remove the Hinge (L) and (R).
5. Remove all the hooks (6 at the top, 5 at the bottom and 3
on each side) of the LCD Front Cabinet Ass'y, and remove
the LCD Front Cabinet Ass'y.
* The Hooks can be removed more easily by repeatedly
inserting a screwdriver with a protective cloth wound around
it between the LCD Front Cabinet Ass'y and LCD Rear
Cabinet Ass'y, and sliding it.
* Take care not to scratch or mark the exterior.
6.2.15. Removing the LCD Unit/LCD Cable
Preparation: Make sure that the steps in sections 6.2.1 to
6.2.4 and section 6.2.14 have been taken first.
1. Remove the two Screws (c) of the LCD Hook.
Screw (c): DFHE5025XA
2. Lift the LCD Unit from the LCD Rear Cabinet Ass'y, and turn
it over in front.
3. Peel off the two tapes anchoring the LCD Cable (Inverter).
4. Disconnect the Inverter Cable and LCD Cable (Inverter)
from the Inverter Board, and then remove the LCD Unit.
5. Peel off the Conductive Cloth anchoring the LCD Cable.
6. Disconnect the LCD Cable form the LCD Connector.
* The Conductive Cloth cannot be re-used.
Use a new one instead.

6.2.16. Removing the Inverter Board

Preparation: Make sure that the steps in sections 6.2.1 to
6.2.4 and in sections 6.2.14 and 6.2.15 have been taken first.
1. Peel off the tape from the LCD Rear Cabinet Ass'y, and
then remove the Inverter Board.
30