Removing The Lcd Unit; Removing The Inverter Board - Panasonic CF-T1 Service Manual

6.2.9. Removing the PCMCIA Door
Preparation : perform the section 5.2.1.~5.2.5. first.
1. Curve the PCMCIA Spring in the direction of an arrow, and
then remove the Short Shaft from the hole.
Cautions :
Keep in mind that the PCMCIA Spring also separates
simultaneously from the Axis of the longer one at the
time of removal.
At the time of removal, the PCMCIA Spring also
separates simultaneously from the Long Shaft.
6.2.10. Removing the LCD Front Ass´y /
Hinge (L, R)
Preparation : perform the section 5.2.1.~5.2.4. first.
1. Remove the 6 Screws (K) (The Hinge is made free).
Screw (K) : DXQN26+A35NL
2. Put in the nail between the LCD Front Ass´y and the LCD
Rear Cover, and then unhooks in order of the following
figure.
3. Remove the LCD front Ass´y from the Latch side and, finally
remove the Hinge side, and then remove the LCD Front
Ass´y and Hinge(L, R).

6.2.11. Removing the LCD unit

Preparation : perform the section 5.2.1.~5.2.4., 5.2.10. first.
1. Remove the LCD Cable from the LCD Unit.
2. Tear off the 2 Tapes.
3. Remove the Back Light Cable from the Inverter Board, and
then remove the LCD Unit.

6.2.12. Removing the Inverter Board

Preparation : perform the section 5.2.1.~5.2.4., 5.2.10.,
5.2.11. first.
1. Tear off the 2 Tapes.
2. Remove the LCD Cable from the Inverter Connector, and
then remove the Inverter Board.
31