Actuator Scrub Deck Removal & Replacement - Windsor Saber Cutter SCX264 Operating Instructions Manual

Maintenance
Actuator Scrub Deck Removal &
Replacement
Before leaving or servicing machine, stop on a level
surface, turn off machine and set parking brake (If
option is installed).
1. Remove front cover.
2. Remove the two nuts below the scrub deck that
attach the actuator bracket.
3. Remove clevis pin and rue ring from lower bracket
of actuator, make sure not allow actuator bracket to
rotate.
4. Disconnect actuator from wiring harness.
5. Remove upper clevis pin and rue ring from actuator
bracket.
6. Reverse steps to install.
32
Scrub Deck Actuator Adjustment
The actuator will need to be adjusted when replaced.
To adjust the actuator:
1. While holding actuator barrel to prevent it from
2. Turn barrel out one or more full turns to assure that
3. While holding actuator barrel to prevent it from
4. With actuator fully retracted, turn barrel in until it
5. At the bottomed out position, turn the barrel out 1
6. Connect actuator to lift linkage.
7. Check travel of actuator during operation.
86400260 Manual Operators - Cutter 24V Deluxe
spinning, apply power to the actuator such that it is
fully extended. Positive power to white wire, and
negative/ground to black. Limit switch within
actuator will stop it.
when it is retracted it will not bind against itself.
spinning, apply power to the actuator such that it is
fully retracted. Positive power to black wire, and
negative/ground to white wire. Limit switch within
actuator will stop it.
touches the base of the threaded shaft.
1/2 turns, then enough more to allow connection to
lift linkage.