Squeegee Lift Lever - Windsor Saber Cutter SCX264 Operating Instructions Manual

Operations
7. Actuator Switch
Adjusts the amount of brush pressure to the floor by
raising or lowering the scrub deck.
To increase brush pressure, press the bottom of the
switch.
To decrease brush pressure or rise the scrub deck,
press the top of the switch.
8. Solution Control Knob
Controls solution flow to scrub deck.
To increase flow, rotate knob clockwise.
To decrease flow, rotate knob counterclockwise.
If the brush motors are turned off or the propel control
levers are in neutral, the flow is automatically inter-
rupted until the motors are turned on again. This
feature prevents unintentional draining of the solution
tank and allows the operator to adjust the solution flow
to the scrub deck without resetting each time the
scrubbing operation is interrupted.
9. Vacuum Switch
Controls the vacuum motor.
To start vacuum motor, press the bottom of the switch.
To stop vacuum motor, press the top of the
16

10. Squeegee Lift Lever

Raises and lowers the squeegee.
To lower the squeegee, lift the lever from its raised
position.
To raise the squeegee, lift the lever from its lowered
position.
11. Squeegee Pitch Adjustment Knob
Adjusts the deflection at the ends of the squeegee.
To increase squeegee blade deflection at the ends, turn
knob counterclockwise.
To decrease squeegee blade deflection at the ends,
turn knob clockwise.
12. Squeegee Deflection Adjustment
Adjusts the deflection along the entire length of the
squeegee.
To increase squeegee blade deflection along the entire
length, turn the two knobs at the squeegee ends
counter-clockwise.
To decrease squeegee blade deflection along the entire
length, turn the two knobs at the squeegee ends clock-
wise.
86400260 Manual Operators - Cutter 24V Deluxe
Knobs