Setting The Lighting On The Camera Body - Pentax K-1 Operating Manual

4
Press E.
5
Press F.
The [E-Dial Programming] screen reappears.
Repeat Steps 2 to 5.
6
Press F twice.
t Memo
• If you select [Rotation Direction] in Step 2, you can reverse
the effect obtained by turning Q or R.
6
100
Setting the Lighting on the Camera
Body
Specifying the Illumination Button Settings
You can set whether to turn on the lights for the following
camera parts when 8 is pressed.
Set in [Illumination Settings] of the
D2 menu. Selecting [Off] provides no
illumination even when 8 is
pressed.
LCD Panel Off, Low, High
Backside Controls Off, Low, High
Lens Mount Off, On
Card Slot/Connector Off, On
Setting the Illumination of the Indicator Lamps
You can set whether to light up the following indicator lamps on
the camera body.
Set in [Indicator Lamps] of the D2
menu.
For [Self-timer], the self-timer lamp
blinks during the countdown for the
drive mode [Self-timer (12 sec.)]. For
[Remote Control], the remote control
receiver lamp blinks during the
standby for shooting.
Wi-Fi Off, Low, High
GPS Off, Low, High
Self-timer Off, On
Remote Control Off, On
D2
Illumination Settings Illumination Settings
LCD Panel LCD Panel
Backside Controls Backside Controls
Lens Mount Lens Mount
Card Slot/Connector Card Slot/Connector
Pressing the illumination button Pressing the illumination button
will provide high illumination will provide high illumination
for the LCD panel for the LCD panel
Indicator Lamps Indicator Lamps
Wi-Fi Wi-Fi
GPS GPS
Self-timer Self-timer
Remote Control Remote Control