Problems - Melitta Caffeo Passione Varianza CS Operating Instructions Manual

Problems

Changing the water filter
Insert a new water filter (see section Inserting the water filter on page 99).
Permanently de-registering the water filter
If you have removed an inserted water filter and want to continue operat-
ing the appliance without a water filter, de-register the water filter from the
appliance:
1. Remove the water tank.
2. Remove the water filter (see Fig. 19).
3. Fill the water tank.
4. Press the "Service" button and also the "Large cup" direct key for longer
than 2 seconds.
» The water filter is de-registered.
» The water hardness is reset to the water hardness that the appliance
had stored prior to inserting a water filter.
5. Adjust the water hardness if necessary (see section 7.4 Setting the water
hardness on page 84).
9 Problems
If the actions listed below fail to rectify the problems or other problems not
listed here occur, contact our hotline (local rate).
United Kingdom: +44 (0)800/ 0288 002
Problem
Coffee only emerges as
drips from the outlet.
Coffee does not flow.
100
Cause
Grinding fineness is
too fine.
Appliance is soiled.
Appliance is covered
inside with limescale.
Water tank is not filled
or is not correctly
inserted.
Brewing unit is
clogged.
Action
Set a coarser grinding fine-
ƒ
ness (see section 7.7 one
page 86).
Clean the brewing unit (see
ƒ
section 8.2 one page 88).
Run the cleaning pro-
ƒ
gramme (see section 8.4 one
page 91).
Run the descaling pro-
ƒ
gram (see section 8.5 one
page 94).
Fill the water tank and ensure
ƒ
it is positioned correctly (see
chapter 4.4 one page 70).
ƒ Clean the brewing unit (see
chapter 8.2 one page 88).