– Do not undertake any changes You must observe the safety to the appliance, its components instructions to avoid dangers. Melitta ® accepts no liability for damage caused or its accessories. by failure to observe the safety –...
Page 5
maintenance must not be undertaken by children younger Risk of burning and scalding than 8 years of age. Children Escaping fl uids and steam may over 8 years of age must be be very hot. Parts of the appliance supervised during cleaning and also become very hot.
Page 6
Drip tray with cup plate and coffee Appliance is heating grounds container as well as Flashing up or coffee is being display for full drip tray dispensed. Height-adjustable outlet Change the Melitta ® Illuminated Claris water fi lter ® ON/OFF button Filter change in...
Page 7
8. • The appliance is ready for operation. • Fill the bean container with suitable • After using the appliance for the fi rst coffee beans. time, insert the Melitta Claris water ® ® • Put the lid back on.
Page 8
Preparing milk froth and heating • Press the ON/OFF button to switch milk and water the appliance on or off. If necessary, the appliance performs an automatic rinse. Warning! Preparation There is a risk of burn injuries and scalding due hot steam and the hot •...
Page 9
fi lter, it is automatically set at hardness It is recommended to rinse the level 1. Cappuccinatore on a weekly basis with ® ® the milk cleaner system from Melitta . Use ® Melitta Claris water fi lter the milk cleaning solution instead of clear...
Setting the water hardness • Press and hold the buttons for approx. 3 seconds, then release. The appliance includes a test strip to appears on the display. determine the water hardness. • Empty the drip tray and insert without • Determine the hardness of the tap water using the test strip.
(Image F, 6) and the is fl ashing. air intake pipe (Image F, 2) from the Only use Melitta cleaning tabs. ® connecting piece (Image F, 5). Switch off the appliance.
(„Setting the cleaning programme (takes about 5 the water hardness “, page 23). minutes). Only use Melitta ® ANTI CALC. Cleaning phase 3 ( • Switch off the appliance. When illuminates, proceed as follows: •...
Other settings • Turn the valve switch 11 clockwise until the stop. is fl ashing. Water will fl ow intermittently into the coffee grounds Energy-saving mode container (takes about 10 minutes). After the last action, the appliance is then illuminated. switches automatically (depending on the •...
Auto-OFF function Adjusting the grinding fi neness The appliance switches off automatically The grinding fi neness was set before the after the last action (depending on the appliance was delivered. We therefore setting). From the factory, the appliance is recommend to only adjust the grinding set at 30 minutes fi...
Page 15
Transport, Storage and Transport Disposal • Vent the appliance. • Empty and clean the drip tray and coffee Venting grounds container. • Empty the water reservoir and th bean Warning! container. If necessary, vacuum out There is a risk of burn injuries and beans that are stuck at the bottom.
Troubleshooting Fault Cause Measure Adjust the grinding fi neness more coarse. Coffee only fl ows drop-by- Grinding fi neness is too fi ne. Clean the brewing unit. drop. Perform a descaling or cleaning programme if necessary. Water tank not fi lled or Fill the water tank and make sure it is incorrectly inserted.