Charging The Mc35 - Motorola MC35 EDA User Manual

1 Fi r s t T hi ng s F i rs t
Preparing to use your MC35
To install the battery pack:
Align the tabs on the battery pack with the grooves on the rear side of the device, and
then insert the battery pack in place. The battery pack locks to the chassis with an
audible click.
To uninstall the battery pack:
1 If the device is on, press the Power button
Wait for five seconds to allow the device to completely power off.
2 Slide the battery latch toward the unlock icon
the chassis (1).
3 Completely detach the battery pack from the device (2).

Charging the MC35

Initial charging of a standard life battery takes about four hours. The extended life battery
type requires at least eight hours. After the initial charging, charge your device everyday
to restore the battery to full capacity. Charge your device using the AC adapter cable, see
instructions below.
While waiting for the initial charging to complete, install Microsoft
higher on your computer to prepare for the initial synchronization procedure. Refer to the
next section for instructions.
To charge your device:
NOTE: Use the clip plug applicable in your country.
1 Slide the replaceable clip plug into the AC adapter until it locks into place with an
audible click.
2
to turn off the device.
to release the battery pack from
2
1
®
ActiveSync
®
4.2 or