Tiptop Audio Trigger Riot User Manual page 5

Riot patch 2: OK I like it, let's go pro Continue...
+
PRESETS
AND BANKS
P1 P2 P3 P4
B1 B2 B3 B4
beat loop start end
sync
INDEPENDENT
/MATRIX
MASTER
KNOB
BOSS
TAP BPM/
CYCLE TEMPO CYCLE RST/CLR
BUTTON
OUT
clock source
DinSync
reset F/L
IN RESET
IN OUT
CLOCK
Tipt p
+
A u d i o
3. Now that we got a beat going, lets save it, press and hold P1 until the display
says SAVE. That's it, this sequence and cycle length are now stored in preset 1.
The display will show P1B1, this is Preset 1 at Bank 1 (assuming you are in
bank 1)
4.
Lets continue the Riot, turn knob 6 and set it to 13, set knob 7 to 17. Now
lets save this into preset 2, press and hold P2 till the display say SAVE. That
sequence is now stored in preset 2. Now try toggling between P1 and P2 as
you like. To finish this patch, lets clear everything, press and hold RST/CLR
button, the Riot will clear all the settings so you can start from scratch again.
The presets are still saved if you want to load them. Clear is great if you feel
you just want to experiment with stuff, you can always hit Clear at any time
to clear it all up and start from scratch.
To summarize, you just did the following:
Set the Riot Cycle length by setting the start and end points to 64
Set BPM
Set different divisions for bass drum on OUT 1
Set different divisions for Snare drum on OUT 2
Use the MUTE/SEL buttons to mute channels 1 and 2.
Save the sequence to a Preset
Do changes to the sequence and save those to another Preset
Toggle between Presets.
Clear the Riot to get started again.
T r i g g e r R i o t
MODE DIVIDE STEPS PROBABILITY SPEED
A B C
1 2 3
1
5 6 7
2
3
4
A B
MUTE/ MUTE/
SEL A SEL B
+
CLOCK TIME PULSE
SHIFT SHIFT WIDTH
MUTE/SEL1
D
1
4
MUTE/SEL2
2
8
MUTE/SEL3
3
MUTE/SEL4
4
C D
HOLD ON POWER-UP
TO LOAD USB
MUTE/ MUTE/
SEL C SEL D
+
5
SD808 BD808
L E V E L L E V E L
TONE TONE
SNAPPY DECAY
ACCENT ACCENT
ACCENT IN ACCENT IN
GATE IN GATE IN
SD OUT BD OUT
Tiptop Tiptop
Audio Audio
MIX