VeriFone Omni 3200 Reference Manual page 54

Omni 3200 Reference Manual
Table 10 Test the Bar Code Reader
Display
1. (Application Prompt)
(or)
DOWNLOAD NEEDED
2. SYSTEM PASSWORD?
3. SYSTEM= (firmware ID)
4. SYSTEM DIAG
5. (NNN-NNN-NNN)
42
To enter System Mode, press [FUNC/ENTER] and [7]
simultaneously.
Key in the System Password and press [FUNC/
ENTER].
Press [4] to initiate system diagnostic tests.
To test a bar code reader/wand:
Swipe the tip of the wand in either direction across a
bar code symbol.
NOTE: The current Omni 3200 firmware supports two
bar code optical recognition features: 'Raw timing' and
'Code 39 and EAN/UPC'.
If the bar code is read successfully, the numeric value
of the bar code is displayed. (This numeric value is
usually imprinted above the vertical lines of the bar
code, and includes hyphens.)
If the bar code could not be read, the SYSTEM DIAG
prompt continues to be displayed. In this case, repeat
the procedure with another bar code.
NOTE: If a diagnostic test fails several times, contact
your local Help desk, or call the VeriFone Customer
Support Hot Line, for instructions.
To return to the SYSTEM= prompt, press [CLEAR].
To exit System Mode and restart the terminal
application, press [CLEAR] again.
Action
Local and Remote Functions