Table of Contents
Advertisement
M
ONACO
2000
• Locate the slide-out motor. It is located in a storage compartment under
the slide-out room (center of room).
• Rotate the lever protruding out of the black housing of the motor assembly (brake
release lever) to disengage brake. NOTE: There is a label showing ENGAGED and
DISENGAGED.
• The room is now free to move. Locate the slide-out rail assemblies (one on each
side of the motor assembly) and 3/4" hex coupling on the end of the drive shaft.
• Using a 3/4" wrench or rachet, crank the room either in or out completely
(depending on your need).
• When the room is fully in (or out) have one person put pressure on the
wrench/rachet to ensure a tight seal while the other person returns the motor
brake lever to the engaged positioin. This will ensure the room is locked into a
sealed position.
• Install transit bars (if so equipped) and take the motorhome to an authorized
dealer for service.
When the slide-out room motor brake lever is disengaged the room will not
lock into place, and therefore will not be sealed from the outdoors.
Maintenance
Do not work on your systems unless the battery is disconnected.
• When the room is out, visually inspect the inner rail assemblies. Check for for-
eign matter of other objects. Remove any debris that may be present.
• If the system squeaks or makes any noise it is permissible to apply a coat of
lithium grease to the rollers and/or bearing sleeves. Wipe off any excess lubri-
cant.
• There is no need to lubricate the gear or gear rack. This system is designed to
operate without lubricant to these components.
3-24
Appliances & Equipment
Appliances & Equipment
WARNING
!
!
CAUTION
!
!
Monarch
Hide quick links:
Advertisement
Table of Contents
