Starting System - Robin DY23-2D Service Manual

7 . STARTING SYSTEM
-
7 - 1 RECOIL STARTER
I
The recoil starter hardly has a trouble in the normal use, .however, in case it has a
trouble
or
at the time of lubrication, perform disassembly and reassembly in the
following procedures
:
Tools to be used
:
Box spanner (spanner), Cutting pliers (pliers) and
Screw driver
The following explanation is applicable to the recoil starter for "D"
type
engines.
For "B" type models, reverse the direction of rotation to achieve proper service
work.
7 - 1
- 1 HOW TO DISASSEMBLE (D Type)
( 1 ) Remove t h e recoil s t a r t e r from the
engine with a
box spanner.
(2) Pull the starting knob and pull out
the starter rope for 30 to 40 cm. Firmly
press the reel with a thumb as shown
in Fig. 79 so that the reel should not
make reverse turn at the place where
the reel notch comes to the outlet of
starter rope. Pull out the starter rope
to the inside of recoil starter with
a screwdriver.
Then, utilize the reel notch, and rewind
it until the rotation stops in the
arrowhead direction, braking the reel
rotation with a thumb.
(3) When removing, take out the parts
in the order of the numbering in Fig.
80.
1. "U" type snap ring
2. Thrust washer
3. Friction spring cover
4. Return spring
5. Friction spring
6.
Ratchet
Meantime, for removing the "U" type
snap ring, nip the shaft with cutting
pliers and push it out.
STARTER ROPE
/q
STARTER NKOB
FIG. 79
2
FIG. 80
- 51
-