Starting System; Recoil Starter - Robin EH11/W01-115 Repair Manual

STARTING SYSTEM
RECOIL STARTER
Disassembly and Reassembly
Figures 7-1
-
7-10
A WARNING: A loaded power spring operates
under great pressure. To avoid personal injury,
use care to keep power spring in housing. DO
NOT remove spring unless for replacement.
1. Refer to Figure 7-1. Pull starter knob out from
housing about 16 in. (40 cm). Hold housing and
reel to prevent reel from rewinding.
NoTCH
Figure 7-1.
2. Pull out rope to the inside of recoil starter and
press rope into notch on reel. Release reel to let
spring mechanism slowly unwind.
3. Refer to Figures 7-2 and 7-3. Remove return
'
spring, friction spring or plate and ratchets.
4.
Refer to Figure 7-4. Slowly lift reel, turning lightly
left to right, from support shaft in housing.
Inspect rope. Replace if damaged or worn.
CAUTION: Use rope of same length and
Refer to Figure 7-5. Install new rope in handle.
Tie knot as illustrated about 1
%
in. (35 mm) from
end. Pull knot tight and fit into top of handle.
Refer to Figure
7-6.
Insert other end of rope
through housing guide bushing and through
hole in reel groove. Pull rope through cavity
opening. Make knot as illustrated about
1
in. (25
mm) from end. Fit knot into cavity.
A
diameter as originally furnished.
, P L A T E
FRICTION
RETURN SPRING
6
QT=
RATCH ET
Figure
7-2.
Models WO1-115 and WO1-150
U-SNAP RING
THRUST WASHER
FRICTION
SPRING
COVER
%
'
/FRICTION SPRING
RATCHETS
Figure 7-3. Model
WO1-210
7-1