WARNING : The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. NOTICE FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIA EMISSION CONTROL WARRANTY are applicable to only those engines complied with EPA (Environmental Protection Agency) and CARB (California Air Resources Board) emission regulations in the U.S.A.
Page 5
FEDERAL EMISSION COMPONENT DEFECT WARRANTY EMISSION COMPONENT DEFECT WARRANTY COVERAGE - This emission warranty is applicable in all States, except the State of California Fuji Heavy Industries Ltd. and Robin America Inc., Wood Dale Illinois, (herein "ROBIN AMERICA") warrant to the initial retail purchaser and each subsequent owner, that this utility equipment engine (herein "engine") was designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U.S.
Page 6
*The replacement parts used for required maintenance services. *Consequential damages such as loss of time, inconvenience, loss of use of the engine of equipment, etc. *Diagnosis and inspection charges that do not result in warranty-eligible service being performed. *Any non-authorized replacement part, or malfunction of authorized parts due to use of non- authorized parts.
CALIFORNIA EMISSIONS CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The California Air Resources Board and FUJI HEAVY INDUSTRIES LTD. are pleased to explain the emissions control system’s warranty on your 2007 and later small off-road engine. In California, new equipment that use small off-engines must be designed, built, and equipped to meet the State’s stringent anti-smog standards.
Page 8
DEFECTS WARRANTY REQUIREMENTS: (a) The warranty period begins on the date the engine or equipment is delivered to an ultimate purchaser. (b) General Emissions Warranty Coverage. FUJI HEAVY INDUSTRIES LTD. must warrant to the ultimate purchaser and each subsequent owner that the engine or equipment is: (1) Designed, built, and equipped so as to conform with all applicable regulations adopted by the Air Resources Board;...
Page 9
(8) Throughout the emissions warranty period defined in Subsection (b)(2), the manufacturer must maintain a supply of warranted parts sufficient to meet the expected demand for such parts. (9) Any replacement part may be used in the performance of any warranty maintenance or repairs and must be provided without charge to the owner.
Page 10
(e) MAINTENANCE STATEMENTS It is your responsibility to have all scheduled inspection and maintenance services performed at the times recommended in the 2007 and later Owner's Manual and to retain proof that inspection and maintenance services are performed at the times when recommended.
Page 11
FOREWORD Thank you very much for purchasing a ROBIN ENGINE. Your ROBIN ENGINE can supply the power to operate various sorts of machines and equipment. Please take a moment to familiarize yourself with the proper operation and maintenance procedures in order to maximize the safe and efficient use of this product.
Page 13
SYMBOLS Read the owner's manual. Stay clear of the hot surface. Exhaust gas is poisonous. Do not operate in an unventilated area. Stop the engine before refueling. Fire, open flame and smoking prohibited. Plus ; On (Run) positive polarity Off (Stop) Battery Engine start Engine oil...
1. SAFETY PRECAUTIONS Please make sure you review each precaution carefully. Pay special attention to statement preceded by the following words. WARNING “WARNING” indicates a strong possibility of severe personal injury or loss of life if instructions are not followed. “CAUTION”...
Page 15
WARNING : OTHER SAFETY PRECAUTIONS Place the protective covers over the rotating parts. If rotating parts such as the drive shaft, pulley, belt, etc. are left exposed, they are potentially hazardous. To prevent injury, equip them with protective covers or shrouds. Be careful of hot parts.
Page 16
CAUTION : PRE-OPERATION CHECKS Carefully check fuel hoses and joints for looseness and fuel leakage. Leaked fuel creates a potentially dangerous situation. Check bolts and nuts for looseness. A loose bolt or nut may cause serious engine trouble. Check the engine oil and refill if necessary. Check the fuel level and refill if necessary.
2. COMPONENTS EH025 Plug cover Air cleaner Stop switch Clutch Fuel tank cap P.T.O. Shaft Fuel tank A Type P Type (Pump) Choke lever Carburetor Muffler Primer pump Oil gauge ( Oil filler ) Starter handle Recoil starter Engine serial No.
Page 18
EH035 Plug cover Air cleaner Clutch Fuel tank cap Fuel tank P.T.O. Shaft A Type Carburetor P Type (Pump) Choke lever Primer pump Muffler Starter handle Oil gauge (Oil filler) Recoil starter - 5 -...
Page 19
EH035V Fuel tank cap Fuel upper level upper level Fuel tank Oil drain screw Spark plug (Plug cap) Muffler Carburetor Choke lever Primer pump Starter handle Air cleaner Oil gauge (Oil filler) Fuel tank Fuel tank cap Recoil starter Clutch - 6 -...
4. OPERATING YOUR ENGINE STARTING STOP SWITCH PRIMER PUMP Set the throttle lever to the idling position. If the stop switch is installed on the engine.Set the stop switch to the Push the primer pump 7 to 10 times position "ON or I ". to feed the fuel to the carburetor.
Page 22
STOPPING STOP SWITCH CHOKE LEVER Set the throttle lever at the low speed position and allow the engine to run at low speed for 2 or 3 minutes before stopping. If the stop switch is installed on the engine.Set the stop switch to the After starting the engine, gradually position "OFF or O ".
5. EASY TROUBLESHOOTING WHEN ENGINE DOES NOT START: Perform the following checks before you take the engine to your Robin dealer. If you still have trouble after completing the checks, take the engine to your nearest Robin dealer. Is the engine switch set ON? Is there enough compression? 1.
6. MAINTENANCE SCHEDULE MAINTENANCE, REPLACEMENT OR REPAIR OF EMISSION CONTROL DEVICES AND SYSTEMS MAY BE PERFORMED BY ANY NONROAD ENGINE REPAIR ESTABLISHMENT OR INDIVIDUAL. DAILY INSPECTION Before running the engine, check the following service items. Excessive vibration,noise Clean air cleaner element Safe surroundings Enough gasoline Enough clean engine oil...
Page 25
Periodic Maintenance Schedule table Every 8 hours Every Every Maintenance Items 200 hours (daily) 50 hours Clean engine and check bolts and nuts (Daily) (Refill daily Check and refill engine oil up to upper level) Clean air cleaner Change engine oil (*Note 1) (Initial 20 hours) Clean spark plug...
Page 27
3) Remove the oil gauge, then tilt the engine and drain the oil into a pan or other receptacle. (EH035V) Remove the oil drain screw and drain the oil. 4) Put the engine on a level surface, then fill with the oil up to the point of overflowing the filler neck.
Page 28
Wash the fuel filter with kerosene. After washing, reassemble it. If the fuel filter is heavy dirty, replace it with new one. CLEANING AIR CLEANER EH025 Choke lever Dirty air cleaner element will cause Place so that the cutout is here (top left)
Page 29
CHECKING BOLTS, NUTS AND SCREWS Retighten loose bolts and nuts. Check for fuel and oil leaks. Replace damaged parts with new ones. Keep safety in your mind. FUEL PIPE REPLACEMENT Replace the fuel pipe every 1 year. If the fuel leakage is found on the fuel pipe, replace it immediately.
8. PREPARATIONS FOR STORAGE DISCHARGE FUEL (NO SMOKING !) In case the engine is not going to be used for more than one month, discharge fuel thoroughly from fuel tank and carburetor in order to prevent from hard starting and/or poor engine operation due to deteriorated fuel when you use the engine next time.
Need help?
Do you have a question about the EH025 and is the answer not in the manual?
Questions and answers
épaisseur cale pour bobine eh025