Starting System; Recoil Starter; How To Disassemble - Robin EH12 Service Manual

9. STARTING SYSTEM
9-1 RECOIL STARTER
When repairing recoil starter, disassemble and reassemble in the following procedures.
Tools
:
Socket wrench, Needle nose pliers, Screw driver
[NOTE]
The following explanation is applicable to the recoil starter for"D" type engines.
For"B" type models, reverse the direction of rotation to achieve proper service work.
9-1-1 HOW TO DISASSEMBLE (D Type)
(1) Remove recoil starter from engine.
(2) Pull starter knob and pull out starter rope for
30- 40cm to line up notch on reel with outlet
hole for starter rope.
Hold reel with thumb and pull starter rope
inside the starter case with screw driver.
(See Fig.
9-1.)
Rewind reel clockwise until the rotation stops.
When rewinding the reel, control the rotation
by holding starter rope using the notch on the
reel and pressing the reel with thumb.
( 3 ) Remove parts in the following order.
1. Center screw
2.
Friction plate
3. Friction spring
4. Ratchet
5. Ratchet spring
Fig.
9-1
3 d
Fig.
9-2
-
49
-