Connecting Rod - Robin DY23-2D Service Manual

assembly into the cylinder.
Use the piston ring compressor
to
hold
the piston rings.
The "FAN" mark of the connecting rod
have to face flywheel side when
assembled. (See Fig. 45.)
D
1.
Apply enough oil t o t h e piston rings,
connecting rod bearings and cylinder
bore before assembly.
2. Set the
open end of the piston rings
90 degrees apart from
one another
before assembly.
5 - 4 - 3 CONNECTING ROD
(1) Turn the crankshaft t o the bottom
dead center, lightly hammer the piston
head until the connecting rod contacts
the crankpin, and assemble,
(2)
When reassembling the large end cap,
match the alignment mark on the rod.
1. No. lock washer is used for the
2. Tighten the rod bolts securely by the
Tightening torque : 180-200 Kg- cm
connecting rod bolts.
specified tightening torque.
PlSTON RING COMPRESSOR
FIG.
45
FIG. 46
-
29
-