INSTALLATION
Easy Software Setup
WA840G
Electrical Connection to Access Point
Your access point does not have an On/Off power switch and
therefore will only be powered on by plugging in the power adapter.
Use only the original power adapter supplied with your access point.
1
Connect the power adapter to the access point's Power port,
found on the back of the access point.
2
Plug the power adapter into a grounded and surge-protected
power outlet.
The Power LED on the front panel lights green when connected
properly.
Run the Installation Wizard program from the supplied CD-ROM to
quickly set up your network. Once your network is up and running,
refer to Section 3: Configuration for advanced configuration.
SECTION 2
To power
supply
2-7