Electrical Connection To Access Point; Easy Software Setup; Manual Software Setup - Motorola WA840G User Manual

Hide thumbs Also See for WA840G:

Table of Contents

SECTION 2

2-6

Electrical Connection to Access Point

Your AP does not have an On/Off power switch and therefore will

only be powered on by plugging in the power adapter. Use only the

original power adapter supplied with your unit.

Connect the power adapter to the AP's Power port, found on the

back of the unit.

Then plug the power adapter into a grounded and surge

protected power outlet.

The Power LED on the front panel lights green when

connected properly.

Run the Installation Wizard program from the supplied CD-ROM to

quickly setup your network. Once your network is up and running,

refer to Section 3:Configuration for advanced configuration.

If you'd prefer to manually setup your network, use this section to

configure it. This section details the physical connection of the AP to

your network as well as the configuration needed by your PC.

To set up your wireless network:

Physically connect and power on the Access Point

Configure your PCs

Enter Wireless Security settings

SECTION 2, INSTALLATION

INSTALLATION

To power

supply

Table of Contents