Table of Contents
Advertisement
Symptom
Severe noise interference.
The Caller ID does not display.
You cannot register the handset
at the base.
The handset doesn't communicate • Remove the base ID (see "Replacing the Base Setting" on page 21) and
with another handsets.
An extra handset can't join
the conversation.
The handset or the base can't
join the conversation
The answering system does
not work.
• Keep the handset away from microwave ovens, computers, remote
control toys, wireless microphones, alarm systems, intercoms, room
monitors, fluorescent lights, and electrical appliances.
• Move to another location or turn off the source of interference.
• The handset was picked up before the second ring.
• The call was placed through a switchboard.
• Call your local telephone company to verify your Caller ID service is current.
• Charge the battery pack for 15-20 hours.
• Remove the base ID (see "Replacing the Base Setting" on page 21) and
register the handset (see "Register the Handset to the Base" on page 57).
register the handset (see "Register the Handset to the Base" on page 57).
• Make sure that you have registered all handsets.
• Make sure there are not 2 handsets already using the 3-way
conference feature.
• Make sure that more than 2 handsets are not in use.
• When recording a conversation, the 2nd handset (or the base) cannot
join the conversation.
• Make sure the base unit is plugged in.
• Make sure that the answering system is turned on.
• Make sure that the message record time is not set to Announce only
(see page 47).
Suggestion
[ 63 ]
Advertisement
Table of Contents
