Table of Contents
Advertisement
the back RHS side brick forwards and down,
then lift out.
7. Move the back brick fully to the RHS, pull the
back LHS side brick fully forward until it meets the
stay rod, tilt the brick forwards and down, then lift
out.
8. Remove the ashpan and drop fire grate into the
ash compartment.
9. Rotate the back brick to allow clearance from
sides, and lift out through fire door opening.
GLASS
1. How to clean:
The glass will clean itself when there is sufficient
heat generated by burning fuel. If a build-up of cre-
osote occurs on the glass it may be due to draft con-
ditions, poor quality fuel or very slow burning for
along time. Only clean glass when the stove is thor-
oughly cooled. Clean with a liquid detergent taking
care not to scratch the glass with any coal ash
deposits.
2. Glass Replacement: (See Fig.9)
a. Open the door (Part No.21) fully.
b. Remove the four corner screws and clips and
carefully remove the broken glass.
c. Clean the glass recess in the door.
d. Attach adhesive thermal tape to the perimeter of
the replacement glass.
e. Place the thermal tape side of the glass into the
door recess and replace the four corner clips.
f. Tighten screws.
g. Replace glass only with ceramic glass 5mm thick.
CO ALARM
Waterford Stanley recommend the fitting of a CO
Alarm in the same room as the appliance, this is a
requirement under UK Building Regulations.
Further guidance on the installation of a carbon
monoxide alarm is available in BS EN 50292:2002
and from the alarm manufacturers instructions.
Provision of an alarm must not be considered a
substitute for either installing the appliance
correctly or ensuring regular servicing and
maintenance of the appliance and chimney
system.
WARNING:-
If the CO Alarm sounds unexpectedly:-
1. Open Doors and windows to ventilate the
room and then leave the premises.
2. Let the fire go out.
Fig.9
11
Hide quick links:
Advertisement
Table of Contents
