Advertisement
ProduCt IntroduCtIon
This device is a single channel UTP (Ethernet Data + PoE) extender and has the built-in
power supply function (PoE) to supply the power to the camera through the UTP cable.
To overcome problems caused by the short transmission distance (100m or less) of
network equipment, it can be installed in the UTP cable section between the camera and
PoE hub, extending the transmission distance to more than 100m. Since power can be
supplied to the IP camera with PoE, the construction cost can also be saved.
ProduCt Features
Simultaneous transmission of power and IP data to the UTP cable (CAT.5)
y
Support of TCP speed of 100Mbps Full Duplex
y
Each time this device is installed, the maximum transmission distance for
y
Ethernet data is extended by more than 100m.
The number of SPO-100 systems that can be added is limited by the rated capacity of
`
M
the IP camera.
A camera with up to 11.7W power consumption can be connected when
y
power is supplied through the PoE HUB.
Refer to the maximum extensible distance table on page11.
`
M
y Built-in surge-protection circuit for safety
aPPlICatIon
y Application for conventional IP type or Mega Pixel camera
y Area in which an IP camera is installed within 100m of a Web Viewer
y Extended connection between the IP systems (PC or NVR)
English _5
Advertisement
