Recoil Starter Air Vents; Lights - Arctic Cat 120 Sno Pro Operator's Manual

! WARNING
DO NOT bend the ski wear bar
excessively when
Excessive bending of the ski wear
bar may cause premature wear,
breakage, and possible injury.
2. Insert the wear bar studs into the
holes in the ski.
3. Center the wear bar studs in the
holes and install the lock nuts.
4. Tighten lock nuts securely.
RECOIL STARTER AIR
VENTS
It is important for proper engine cool-
ing that the air vents located on the
recoil starter are kept clean. These air
vents should be checked periodically
and cleaned if necessary.
CAUTION
Serious overheating of the engine
and engine damage will result if
the air vents are not kept clean.
20

LIGHTS

The correct headlight bulb is p/n 0609-
251. The correct taillight bulb is p/n
installing. 0230-020. The taillight bulb is accessi-
ble from inside the rear storage com-
partment. It is not necessary to remove
the taillight assembly in order to
change the bulb.
To change the headlight bulb, use the
following procedure:
1. Open the hood; then disconnect
the harness connector from the
headlight bulb.
2. Remove the bulb from the housing
by rotating it counterclockwise
until loose.
CAUTION
Do not touch the glass portion of
the bulb. If the glass portion is
touched, it must be cleaned with a
dry cloth before installing.
3. Install the new bulb into the hous-
ing; then rotate the bulb clockwise
to lock it into place.
The headlight aim can be adjusted to
provide maximum illumination for the
operator. To adjust headlight aim,
adjust the four headlight adjustment
0744-923
screws until maximum illumination for
the operator is apparent.