Self-Diagnosis Function - Sony MXD-D4 Service Manual

General
Power requirements
Where purchased
U.S.A. and Canada
Europe
Certain countries in Asia
Other countries
Power consumption 22 W (less than 1 W at standby)
The self-diagnosis function consists of error codes for customers which are displayed automatically when errors occur, and error codes
which show the error history in the test mode during servicing. For details on how to view error codes for the customer, refer to the
following box in the instruction manual. For details on how to check error codes during servicing, refer to the following "Procedure for
using the Self-Diagnosis Function (Error History Display Mode)".

Self-Diagnosis Function

The deck has a self-diagnosis display. This function shows a three- or five-digit display (a combination of a letter and
figures) and the corresponding message, so you can check the deck's condition.
If such a display appears, check the following table in order to resolve the problem.
Should any problem persist, consult your nearest Sony dealer.
Three- or five-digit display/Message
C11/Protected
C12/Cannot Copy
C13/REC Error
C13/Read Error
C14/TOC Error
C41/Cannot Copy
C71/Din Unlock
E0001/MEMORY NG
E0101/LASER NG
PROCEDURE FOR USING THE SELF-DIAGNOSIS FUNCTION (ERROR HISTORY DISPLAY MODE)
Note: Perform the self-diagnosis function in the "error history display mode" in the test mode. The following describes the least required procedure. Be
careful not to enter other modes by mistake. If you set other modes accidentally, press the
1. Press the (CD), (MD) and
x x
[ AMS
2. Press the l L
[ AMS
3. Turn the l L
[ AMS
4. Turn the l L
[ AMS
5. Turn the l L
[YES]
6. Press the button to sets the error history mode and displays "op rec tm".
7. Select the contents to be displayed or executed using the
[ AMS
8. Press the
l L
[ AMS
9. Press the l L
[MENU/NO]
10. Press the button to display "Err Display" and release the error history mode.
11. To release the test mode, press the
12. To turn the power OFF, turn the
knob.
2
Power requirements
120 V AC, 60 Hz
220 - 230 V AC, 50/60 Hz
220 - 240 V AC, 50/60 Hz
110 - 120 or 220 - 240 V AC
selectable, 50/60 Hz
SELF-DIAGNOSIS FUNCTION
Cause/Remedy
The inserted MD is record-protected.
, Take out the MD, and close the record-protect tab.
An attempt was made to play a disc that is not compatible with this deck (CD-
ROM, MD data disc, etc.).
, Replace the disc.
The recording was not made properly.
, Set the deck in a stable place, and repeat the recording procedure.
The inserted MD is dirty (with smudges, fingerprints, etc.), scratched, or not up to
standards.
, Replace the disc, and repeat the recording procedure.
The deck could not read the TOC of the MD properly.
, Eject the disc, then insert it again.
The deck could not read the TOC of the MD properly.
, Insert another disc.
, If possible, erase all tracks on the MD using the All Erase Function.
The digitally dubbed material cannot be recorded digitally.
A moment's lighting is due to the signals of the digital program being recorded.
This does not affect the recorded material.
While recording from a digital component connected through the DIGITAL
OPTICAL IN connector, the digital connecting cable was unplugged or the digital
component turned off.
, Connect the cable or turn the digital component back on.
There is an error in the internal data that the deck needs in order to operate.
, Consult your nearest Sony dealer.
There ia a problem with the optical pick-up.
, The optical pick-up may have failed. Consult your nearest Sony dealer.
[YES]
buttons at the same time.
]
(MD) knob and (MD) button to display " <To Normal> 0".
x
]
(MD) knob and when " <MD Test> 5" is displayed, press the
]
(MD) knob and when "[Service]" is displayed, press the
]
(MD) knob to display "Err Display".
]
(MD) knob to display or execute the contents selected.
]
(MD) knob another time returns to step 6.
? / button to display " <MD Test> 5".
1
[ AMS ]
(MD) knob and when " <Initial> 8" displayed, press the
l L
Dimensions (approx.) (w/h/d) incl. projecting parts and controls
Mass (approx.)
Supplied accessories
• Audio connecting cords (2)
• Remote commander (remote) (1)
• Sony R6 (size-AA) batteries (2)
• Power plug adaptor (1) (Singaporian model only)
Design and specifications are subject to change without
notice.
[MENU/NO]
[YES]
[ AMS ]
l L
(MD) knob.
430 × 120 × 290 mm
4.7 kg
button to exit the mode.
[ AMS ]
l L
(MD) knob.
button.
[ AMS
l
]
(MD)
L