Introduction; Before Using The Product For The First Time - Martin RUSH MH 6 Wash CT User Manual

Introduction

The RUSH™ MH 6 Wash CT is a fast, powerful, white-light moving head wash
effect. It incorporates twelve long-life LEDs with two warm-white and two cold-
white chips that enable mixing of white tones from 2700 K (warm white) to
7800 K (cold white). The fixture provides smooth electronic dimming, strobe
effects, 540° of pan and 220° of tilt, and a one-tenth peak beam angle that can
be varied from 10° to 60°. It can be controlled by any DMX-compliant
controller. The rugged, lightweight and compact fixture is suitable for both
touring and fixed installations.
The RUSH™ MH 6 Wash CT is supplied with this user manual, a 1.5 m (5 ft.)
power cable (local power plug not included) and an omega-type mounting
bracket for rigging clamp attachment.

Before using the product for the first time

1. Read 'Safety information' on page 4 before installing, operating or
servicing the fixture.
2. Unpack and ensure that there is no transportation damage before using
the fixture. Do not attempt to operate a damaged fixture.
3. If the fixture is not going to be hard-wired to a mains supply, install a local
power plug (not supplied) to the end of the supplied power cable.
4. Before operating, ensure that the voltage and frequency of the power
supply match the power requirements of the fixture.
5. Check the support pages on the Martin Professional website at
www.martin.com for the most recent user documentation and technical
information about the fixture. Martin™ user manual revisions are identified
by the revision letter at the bottom of the inside cover.
Note that whenever AC power is applied to the fixture, it will reset all effects
and functions to their home positions. Be prepared for the fixture head to
move. A reset usually takes around 20 seconds.
RUSH™ MH 6 Wash CT User Manual 9