Motorola 326X V.34 User Manual page 42

Installing a Ferrite Cylinder on an Audio or Network Management Cable
Do the following for each cable:
To Connector On
Modem Rear Panel
Figure 2-5. Installing a Ferrite Cylinder on an Audio Cable
Installing a Ferrite Cylinder on a DTE Cable
Do the following for each DTE cable:
2-8 Installing the Modem
1) Snugly wrap the cable twice completely around the cylinder (Figure 2-5).
2) Set the cable into the cylinder cutouts.
3) Ensure that 1 to 1-1 2 inches of the cable protrude from the cylinder (on the
end you insert into the backplane connector).
4) Snap the cylinder closed. You can reopen and close it to reset the cable.
5) Insert the cable into the modem backplane connector (with the ferrite cylinder
close to the backplane connector).
Cable Looped Twice
1 2
1"- / " 1
1) Pass the DTE cable through the cylinder.
2) Set the cable into the cylinder cutouts.
3) Position the cylinder as close as possible to the plug you install on the back-
plane connector.
4) Snap the cylinder closed. You can reopen and close it to reset the cable.
5) Insert the cable into the DTE connector on the modem backplane connector,
with the ferrite cylinder close to the backplane connector.
To Line Jack
Audio Cable
Cutout
Ferrite Cylinder
Around Cylinder